Proform 785 TL Manuel d'utilisateur Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 34
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
Indoor Antenna
1. Place the VHF
antenna in the
desired loca-
tion. Connect
the 300 ohm
flat wire to the
screws on the
300 ohm to 75
ohm adapter.
2. Connect the
300 to 75 ohm
adapter to the
75 ohm an-
tenna terminal
on the treadmill.
(See assembly
drawing 6 on
page 8 for the
location of the
terminal.)
Outdoor Antenna
Outdoor antennas are subject to weathering that can
reduce signal quality. Inspect the antenna and lead-in
wiring before connecting the antenna. Any service cen-
ter can explain the various outdoor antennas available.
¥ 300 Ohm Flat Wire
1. Refer to the drawing above. Connect the 300 ohm
flat wire to the 300 ohm to 75 ohm adapter.
2. Push the end of the 300 ohm to 75 ohm adapter
into the 75 ohm antenna terminal on the treadmill.
(See assembly drawing 6 on page 8 for the loca-
tion of the terminal.)
¥ 75 Ohm Coaxial Cable
Refer to the drawing in the lower left corner of this page.
Connect the 75 ohm coaxial cable directly to the 75 ohm
antenna terminal on the treadmill. (See assembly draw-
ing 6 on page 8 for the location of the terminal.)
1. Remove the VHF 300 to 75 ohm adapter or the VHF
cable from the antenna terminal.
2. Connect the CATV
cable (75 ohm coaxial
cable) to the 75 ohm
antenna terminal on the
treadmill. (See assem-
bly drawing 6 on page 8
for the location of the
terminal.)
Read the important precautions on pages 2 to 5 of
this manual. Before operat-
ing the TV, make sure that the
on/off switch located on the
front of the motor hood is in
the ÒonÓ position, and that the
power cord is properly
plugged in (see page 9).
Battery Installation
Before the remote
control can be oper-
ated, two ÒAAAÓ
batteries (included)
must be installed.
Slide the battery
cover off the back
of the remote con-
trol. Press two bat-
teries into the re-
mote control. Make
sure that the bat-
teries are turned
as shown.
Reattach the battery cover.
300 to 75 Ohm Adapter
Screwdriver
VHF 300
Ohm Flat
Wire
75 Ohm
Terminal
300 to 75 Ohm
Adapter
VHF Rod
Antenna
Combination
VHF/UHF Antennas
300 Ohm
Flat Wire
75 Ohm
Terminal
on Treadmill
300 to 75
Ohm Adapter
75 Ohm
Coaxial Cable
75 Ohm CATV Cable
75 Ohm CATV Cable
ANTENNA CONNECTIONS
CATV CABLE CONNECTION
BASIC TV OPERATION
OFF
ON
ÒOnÓ
Position
ÒAAAÓ Batteries
Battery
Cover
Remote
Control
17
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 33 34

Commentaires sur ces manuels

Pas de commentaire