Proform 785 TL Manuel d'utilisateur Page 23

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 34
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 22
HOW TO FOLD AND MOVE THE TREADMILL
HOW TO FOLD THE TREADMILL FOR STORAGE
Before folding the treadmill, adjust the incline to the lowest
position. If the incline is not at the lowest position, the
treadmill will be damaged. Next, unplug the power cord.
Caution: You must be able to safely lift 45 pounds (20
kg) in order to raise, lower, or move the treadmill.
1. Hold the treadmill as shown at the right. Caution: To
avoid pinching your hands, do not hold the treadmill
in the locations indicated by the arrows. To decrease
the possibility of injury, bend your legs and keep your
back straight. As you raise the treadmill, make sure to
lift with your legs rather than your back. Raise the
treadmill about halfway to the vertical position.
2. Move your right hand to the position shown and hold the
treadmill firmly. Raise the treadmill until the storage latch
closes over the frame guide. Make sure that the storage
latch closes fully over the frame guide.
To protect the floor or carpet from damage, place a
mat under the treadmill. Keep the treadmill out of di-
rect sunlight. Do not leave the treadmill in the storage
position in temperatures above 85¡ Fahrenheit.
THE WOODGRAIN-FINISH COVER PANEL
When the treadmill is in the storage position, the woodgrain-
finished cover panel will accent your room. If desired, the
cover panel can be removed to display the black-finished
frame cover instead. To remove the cover panel, simply in-
sert your fingers between the lower end of the cover panel
and the frame cover (see the arrow at the right). Pull the
cover panel off the panel fasteners, working your way up
until the cover panel is removed.
After the cover panel is removed, the panel fasteners can be
removed for a cleaner appearance. Using a phillips head
screwdriver, remove one of the panel screws and panel
fasteners from the frame cover. Tighten the panel screw
back into the frame cover. Repeat this process, removing
one panel fastener at a time, until all six panel fasteners
are removed. Press the removed panel fasteners onto the
fasteners on the back of the cover panel. Store the cover
panel away from moisture and dust.
Storage
Latch
Frame
Guide
Closed
23
Do not hold here
Cover Panel
Cover Panel
Frame Cover
Frame
Cover
Panel
Fastener
Panel
Fastener
Fastener
Panel Screw
Vue de la page 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 33 34

Commentaires sur ces manuels

Pas de commentaire